Robert Axle Project Trainer Thru-Axle 1.75x174mm - Black MFPN=00.7115.004.000 } These sockets have a

} These sockets have a machined 3/8 inch drive

Generating 60Nm of torque

KGRD - Layered from natural rubber reinforced with Kevlar fibers - the protection standard for every tire from the Active Line

truly independent High and Low Speed Compression along with an increased range of rebound adjustment

} Collaboration with ODI

Robert Axle Project Trainer Thru-Axle 1.75x174mm - Black MFPN=00.7115.004.000 } These sockets have aRobert Axle Project thru axles allow modern frames to be used with axle mount trainers. For use with bike trainers such as 1up Blackburn Cyclops Kinetic Tacx and more IMPORTANT: Before ordering make sure your specific trainer will accommodate the width of the thru axle equipped bike that you are using Measure trainer at the widest setting and measure the bike frame width at the rear hub The Robert Axle ends will extend 15mm past the frame on each side